Enterasys 802.1Q Especificaciones descargar pdf (Pagina 28)

Configuring Authentication

April 15, 2011 Page 28 of 36

Procedure 15describesRADIUSaccountingconfiguration.

Procedure 15 RADIUS Accounting Configuration

Step Task Command(s)

1. Set the minimum interval at which RADIUS

accounting sends interim updates.

set radius accounting intervalminimum

interval

2. Set the number of seconds between each

RADIUS accounting interim update.

set radius accounting updateinterval

interval

3. Set the number of times a switch will attempt to

contact a RADIUS accounting server.

set radius accounting retries retries

4. Set the amount of time to establish contact with

a RADIUS accounting server before timing out.

set radius accounting timeout timeout

{index | all}

5. Configure the RADIUS accounting server. set radius accounting server {index | all}

ip_address udp-port [server-secret]

6. Enable or disable RADIUS accounting on this

switch.

set radius accounting {enable | disable}

7. Reset RADIUS accounting parameters to default

values or clear server definitions on this switch.

clear radius accounting {[server {index |

all}] [retries {index | all}] [timeout {index |

all}] [intervalminimum] [updateinterval]}

8. Display RADIUS accounting configuration or

statistics.

show radius accounting [updateinterval |

intervalminimum | state | server {index | all}]

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Sin comentarios

Enterasys 802.1Q Especificaciones Pagina 28