Enterasys C2RPS-SYS Guía de instalación descargar pdf (Pagina 30)

Considerations Prior to Installation

3-2 Hardware Installation

Considerations Prior to Installation

Wheninstallingtheswitch,notethefollowing:

•Beforestartingtheinstallationprocedure,notifythenetworkadministratorofthe

installation.

•Followtheinstallationproceduresintheorderaspresentedinthisguide.

•DonotconnecttheswitchtothenetworkuntilyouhaveestablishedthecorrectIP

address.

Required Tools

APhillipsscrewdriverisrequiredtoinstalltheswitchintoarack.

Unpacking the Switch

Unpacktheswitchas follows:

Table 3-1 Contents of Switch Carton

Item Quantity

A2H254-16 Switch

Mounting kit (two mounting brackets and eight M3x6-mm screws for rack mounting)

Rubber feet with adhesive backing for installation on a flat surface

AC power cord (The type of power cord is country dependent.)

This installation guide

Customer Release Notes

URL notice card

1. Opentheboxandremovethepackingmaterialprotectingtheswitch.

2. VerifythatthecontentsofthecartoncontainstheitemslistedinTable3‐1.

3. Removethetapesealonthenon‐conductivebagtoremovetheswitch.

4. Performavisualinspectionoftheswitchforanysignsofphysicaldamage.Contact

EnterasysNetworksifthereareanysignsofdamage.Referto“GettingHelp”on

page1‐6fordetails.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 79 80

Sin comentarios

Enterasys C2RPS-SYS Guía de instalación Pagina 30