Enterasys C2RPS-SYS Guía de instalación descargar pdf (Pagina 45)

Connecting AC and RPS-SYS Power

SecureStack A2 Installation Guide 3-17

C2RPS-SYS Redundant Power System

Ifyouareinstallinganoptionalredundantpowersystem(C2RPS‐SYS),refertothe

installationinstructionssuppliedwiththeSecureStackRPS.Theswitchisconnectedtoa

C2RPS‐PSMusingaC2RPS‐PSMCable.

Figure 3-10 Accessing the RPS Connector

Ifyouareinstallingtheswitchasastandaloneswitch,proceedto“ConnectingtoConsole

PortforLocalManagement”onpage3‐18.Ifyouareinstallingswitchesinastack

configuration,applypowertoeachswitchinorder,accordingtotheprocedureyouusein

“ConfiguringSwitchesinaStack”onpage3‐12.

1 RPS coverplate 3 Screw holes for coverplate

2 Retaining screws to fasten plate

Caution: To prevent damaging the switch, DO NOT connect a Power over

Ethernet-compliant Redundant Power System (C2RPS-POE) to the redundant power

supply connector. The switch is only compatible with the SecureStack C2RPS-SYS

redundant power supply system.

Precaución: No conecte una fuente de poder redundante (RPS) SecureStack PoE

(C2RPS-POE) al cable de corriente. De lo contrario, el dispositivo puede dañarse.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 79 80

Sin comentarios

Enterasys C2RPS-SYS Guía de instalación Pagina 45