Enterasys SSR-GLX70-01 Manual de usuario descargar pdf (Pagina 16)

ISSUES RESOLVED IN E8.2.1.1

10/24/01 P/N: 9038090-17 CUSTOMER RELEASE NOTES Page: 16 of 34

F0615-F Subject to Change Without Notice

Remote Network Monitor Device (RMON) I.D.

When monitoring traffic on the RMON “al-host” table, high protocol ports will report incorrect

protocols. “Quake”, for example, will display as “LDAP”.

F1604

Routing I.D.

Prior to this release, the number of multipath (equal cost) route entries in each route table was 16.

This resulted in the allocation of excessive memory, which was subsequently never used. The

number of multipath (equal cost) route entries has been altered to the more reasonable value of 4,

resulting in the consumption of 30% less memory per route table entry. Because of this, the X-

Pedition can now hold more route table entries and/or avoid low- or out-of-memory conditions.

F1506

When a link goes down within an OSPF or BGP domain, Layer-3 flows may not be properly

removed. This may result in a misdirected flow that will not be removed unless traffic ceases on the

flow for more than 30 seconds.

01770

01763

01757

01358

01801

Serial WAN Module I.D.

Serial WAN modules (i.e. 2-port HSSI, 2-port Serial (SERC), 4-port Serial (SERC), and 4-port Serial

Encrypted (SERCE)) cannot be hot-swapped out of slot 15 in the X-Pedition 8600. Upon attempting

such a hot-swap, the system will fail to perform any other hot-swap request until the X-Pedition is

rebooted.

F1555

Simple Network Management Protocol (SNMP) I.D.

When querying the 'sysHwModuleTable' MIB on an X-Pedition 8000, slot “0” will not register if a

Control Module exists in that slot. This issue was resolved in E8.1.0.7.

F0945

F1083

An SNMP Get or GetNext request for objects in the vrrpMIB may return invalid or incomplete results.

In addition, SNMP Set requests for objects in the vrrpMIB will fail.

F1344

BGP management traps are not currently supported. F1376

If a topology change occurs, and an X-Pedition is the root bridge both before and after the change,

the X-Pedition will send out a new root bridge trap regardless of its previous function as the root.

This issue was resolved in E8.1.0.7.

F1437

When Querying the ‘dot1dTpFdbTable’, addresses belonging to SmartTRUNKs will incorrectly

display port “0”. Subsequently, the user cannot back trace the origin of a specific address. This

issue was resolved in E8.1.0.7.

F1457

Entering the command snmp set mib name <MIB> status disable will cause the X-Pedition to lose

pagination. This issue was resolved in E8.1.0.7.

F1471

The X-Pedition does not send the SNMP trap “envHotSwapOut” when the backup Control Module is

hot-swapped out. This issue was resolved in E8.1.0.10.

F1549

Entering a snmp set command with a duplicate community name will produce an error. When the

erroneous command is negated and the active configuration is saved, the error will still occur when

the command is reentered using the same community name.

F1659

If using SNMP to query the ifTable at the exact time a link goes up or down, the X-Pedition will core-

dump.

F1802

With SNMP turned on, removing the fan tray from an X-Pedition may cause a core dump or print out

an error message. This issue originally appeared in E8.1.0.7, and was resolved in E8.1.0.12.

01809

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

Comentarios a estos manuales

Sin comentarios

Enterasys SSR-GLX70-01 Manual de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Enterasys SSR-GLX70-01