Enterasys SSR-GLX70-01 Manual de usuario descargar pdf (Pagina 20)

KNOWN RESTRICTIONS AND LIMITATIONS

10/24/01 P/N: 9038090-17 CUSTOMER RELEASE NOTES Page: 20 of 34

F0615-F Subject to Change Without Notice

KNOWN RESTRICTIONS AND LIMITATIONS:

Prior to E8.2.0.0, the Known Restrictions and Limitations section contained various hardware/feature

informational statements. As of E8.2.0.0, those statements have been moved to the “Informational Notes” section

of the System Firmware release notes.

6SSRM-02 I.D.

When a 6SSRM-02 or 5SSRM-02 configuration includes the system poweron-selftest on

command in startup, and the X-Pedition is cold booted, the diagnostic programs will run; these

programs will subsequently report failures such as:

%DDT-E-GMAC_PHY_LOOPBACK, (Slot 1, Port 1) : GMAC PHY Loopback : FAILED

%DDT-E-

GMAC_TEST, (Slot 1, Port 1) : GMAC Test : FAILED

%DDT-E-PORT_STATUS, (Slot 1, Port 1) : FAILED

The system will be unable to use desired ports, which will be reported to have failed self-test.

The X-Pedition functions as designed when the system poweron-selftest on command is not

included in the startup configuration.

F1295

Access Control List (ACL) I.D.

Entering save in the ACL editor when no ACLs are defined causes a core dump. This issue was

introduced in E8.2.1.1.

F1955

Address Resolution Protocol (ARP) I.D.

After the negation of an interface configured with an ARP command, the ARP command will

automatically be reassigned to a non-existing interface in the same configuration. Attempts to

negate the ARP command will produce the following error messages:

%CLI-E-FAILED, Execution failed for "no arp set interface int1 keep-time 10"

%INTERFACE-E-NOEXIST, Interface int1 does not exist. Please check the name and try

again.

The user must then recreate the negated interface in order to negate the ARP command.

F0309

When the X-Pedition detects a topology change, it will clear the ARP entries on a specified VLAN

(or an entire ARP table if running STP) in order to ensure that Layer-3 entries maintain their

integrity. This may potentially cause all existing IP connections to re-ARP simultaneously.

Therefore, Enterasys Networks recommends that the user does not enable STP or PVST on

connections to end-stations. If this configuration is necessary, the following commands are

recommended:

stp set port <portlist> edge-port true, or

pvst set port <portlist> edge-port true spanning-tree <vlanname>

The X-Pedition will not consider a link change to an edge-port as a topology change, thereby

reducing the number of unnecessary ARP entries cleared.

F0811

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Comentarios a estos manuales

Sin comentarios

Enterasys SSR-GLX70-01 Manual de usuario Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Enterasys SSR-GLX70-01