Enterasys Enterasys Gold Distributed Forwarding Engine 4G4282-49 Guía de instalación descargar pdf (Pagina 56)

Connecting to COM Port for Local Management

3-24 Installation

WithaUTPstraight‐throughcableandanRJ45‐to‐DB25maleadapter,youcanconnect

productsequippedwithanRJ45COMporttoaHayescompatiblemodemthatsupports

9600 baud.

Connecting to an IBM PC or Compatible Device

ToconnectanIBMPCorcompatibledevice,runningtheVTterminalemulation,toan

Enterasys NetworksmoduleCOMport(Figure 3‐15),proceedasfollows:

1. ConnecttheRJ45connectoratoneendofaUTPstraight‐throughcabletothe

communicationsCOMportontheEnterasys Networksmodule.(TheCOMportis

alsoknownasaConsoleport.)

2. PlugtheRJ45connectorattheotherendoftheUTPstraight‐throughcableintoan

RJ45‐to‐DB9adapter .

3. ConnecttheRJ45‐to‐DB9adaptertothecommunicationsportontheIBMPC.

4. TurnonthePCandconfigureyourVTemulationpackagewiththe

following

parameters:

5. Whentheseparametersareset,theLocalManagementpasswordscreenwilldisplay.

RefertotheappropriateMatrix DFE‐GoldSeriesConfigurationGuideforfurther

information.

Parameter Setting

Mode 7 Bit Control

Transmit Transmit=9600

Bits Parity 8 Bits, No Parity

Stop Bit 1 Stop Bit

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 89 90

Sin comentarios

Enterasys Enterasys Gold Distributed Forwarding Engine 4G4282-49 Guía de instalación Pagina 56