Enterasys 5C105 Guía de instalación descargar pdf (Pagina 38)

Installing Optional GPIMs

3-10

3.3.2 Locking Bar GPIMs

This section describes how to install and remove GPIMs that are equipped with a metal locking

bar.

Refer to Appendix C for cable specifications for the GPIMs.

3.3.2.1 Installing the Locking Bar GPIM

Prepare and install the GPIM into the 5PIM, as follows:

Preparation

Before installing the GPIM, proceed as follows:

1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)

before removing the GPIM from the antistatic packaging.

2. Remove the GPIM from the packaging.

3. If there is a protective dust cover on the port, remove it from the GPIM.

Installation

To install the GPIM, refer to Figure 3-5 (Views A, B, and C) and proceed as follows:

1. Hold the GPIM

➀ with the top of the body ➁ facing up, as shown in View A.

CAUTION: This section applies only to GPIMs equipped with a metal locking bar.

Damage can result to the GPIM and 5PIM if the directions in this manual are not

followed carefully.

The GPIM, 5PIM, and module are sensitive to static discharges. Use an antistatic wrist

strap and observe all static precautions during this procedure. Failure to do so could

result in damage to the GPIM, 5PIM, or module. Always leave the GPIM in the antistatic

bag or an equivalent antistatic container when not installed.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 77 78

Sin comentarios

Enterasys 5C105 Guía de instalación Pagina 38