Enterasys SecureStack A2 A2H123-24 Guía de instalación descargar pdf (Pagina 39)

Connecting AC and RPS-SYS Power

SecureStack A2 Installation Guide 3-13

Figure 3-6 Switch Rear View

3. ObservethepowerCPULED(notshown),locatedonthefrontpanel.Duringthe

initialization,theCPULEDwillstartbyilluminatingsolidamber,thenstartblinking

green,thenblinkingamber,thenblinkinggreenagainuntiltheendofthe

initialization,andthenturnssolidgreen.

Iftheswitchisa

standaloneswitch,itwilltakeapproximately30 secondsforthe

switchtostartup.IftheswitchisastackManager,itcantakeupto3minutesormore

tostartup,dependingonthenumberofMemberswitchesinthestack.

1 AC power cord 2 AC power connector 3 Connector for external redundant power supply

Note: If the CPU LED illuminates solid red, there was a critical failure. For more

information about the LED indications and troubleshooting, refer to Chapter 4. If you need

additional help, contact Enterasys Networks. Refer to “Getting Help” on page xviii for

details.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 63 64

Sin comentarios

Enterasys SecureStack A2 A2H123-24 Guía de instalación Pagina 39