Enterasys C2RPS-SYS Guía de instalación descargar pdf (Pagina 34)

Installing the Switch on a Flat Surface

3-6 Hardware Installation

2. Removethe cablesconnectedtotheMini‐GBIC.

3. LocatethereleasetabunderthefrontendoftheMini‐GBIC.Forthetypeof

Mini‐GBICshowninFigure 3‐3, pushinonthereleasetabasfarasitwillgotorelease

theMini‐GBICfrom theportslot.

ForthetypeofMini‐GBICshowninFigure 3‐4,pull

outonthereleasetabtoreleasetheMini‐GBICfromthe portslot.

4. GraspthesidesoftheMini‐GBICandpullitstraightoutoftheportslot.

IfstoringorshippingaMini‐GBICwhichhas

afiber‐opticconnector,insertitsprotective

dustcovertoprotecttheendsofthefiber‐opticfibersfromdustorcontamination.

Installing the Switch on a Flat Surface

Wheninstallingtheswitchonaflatsurface,theinstallationoftherubber feetis

recommendedtopreventtheswitchfromslidingonaflatsurface.Installingtherubber

feetisoptionalifyouareinstallingtheswitchinarack.Toinstalltherubberfeet,proceed

to“Installingthe

RubberFeet”instructionsbelow.Forinstructionstorackmountthe

switch,proceedto“RackMountingtheSwitch”onpage 3‐9.

Installing the Rubber Feet

Toinstalltherubberfeet,refertoFigure 3‐5andproceedasfollows:

1. Placetheswitchonitsbackonasturdyflatsurfacetogainaccesstothebottomofthe

chassis.

2. Removethe fourrubberfeetfromtheirplasticbagintheshipping box.

3. Locatethefourmarkedlocationson

thebottomfourcornersofthechassis.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 77 78

Sin comentarios

Enterasys C2RPS-SYS Guía de instalación Pagina 34