Enterasys Matrix 7GR4202-30 Guía de instalación descargar pdf (Pagina 32)

Installing an Optional Ethernet Expansion Module

3-4 Hardware Installation

3.4 INSTALLING AN OPTIONAL ETHERNET EXPANSION MODULE

Installing an Ethernet expansion module involves the following:

• Removing the Front Panel Coverplate (Section 3.4.1)

• Installing the Ethernet Expansion Module (Section 3.4.2)

• Installing GBICs (Section 3.5) or Mini-GBICs (Section 3.6). This is dependent on if a

1G-2GBIC or 1G-2MGBIC was installed.

3.4.1 Removing the Front Panel Coverplate

Refer to Figure 3-1 and proceed as follows:

1. Attach the antistatic wrist strap (refer to the instructions on the antistatic wrist strap package).

2. Place the device

➀ on an antistatic pad (not shown) on a sturdy flat surface.

3. Loosen the two captive screws

➁ until the coverplate ➂ is released from the front panel ➃.

4. Remove the coverplate

➂ from the front panel. Save the coverplate for future use if necessary.

NOTE: Install any optional equipment before proceeding to Section 3.7.

CAUTION: An antistatic wrist strap is required to perform the following procedures to

minimize ESD damage to the devices involved.

NOTE: Unless noted otherwise, the following instructions apply to both the 1H582-25

and 1H582-51.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 91 92

Sin comentarios

Enterasys Matrix 7GR4202-30 Guía de instalación Pagina 32