Enterasys 2S4082-25-SYS Guía de instalación descargar pdf (Pagina 41)

Enterasys NAC Controller Hardware Installation Guide 4-1

NAC Controller PEP Installation

ThischapterprovidestheinstructionstoinstalltheNACControllerPEPs2S4082‐25and7S4280‐19

andtheMini‐GBICsinterfacemodules.

FollowtheorderofthesectionslistedbelowtocorrectlyinstalltheNACControllerPEPintothe

chassis.

Required Tools

ToolsneededtoinstalltheNACControllerPEPandoptionsinclude:

• Phillipsscrewdri ver

•Flatbladescrewdriver

Unpacking the NAC Controller PEP

UnpacktheNACControllerPEPasfollows:

1. Opentheboxandremovethepackingmaterialprotectingthemodule.

Electrical Hazard: Only qualified personnel should perform installation procedures.

Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes

Personal vorgenommen werden.

Important Notice

Read the Release Notes shipped with the NAC Controller PEP to check for any exceptions to the supported

features and operation documented in this guide.

For information about... Refer to page...

Required Tools 4-1

Unpacking the NAC Controller PEP 4-1

Installing Optional Mini-GBICs 4-2

Installing NAC Controller PEP into the Matrix N1 Chassis 4-5

Connecting to the Network 4-7

Connecting to COM Port for Local Management 4-14

Completing the Installation 4-18

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 107 108

Sin comentarios

Enterasys 2S4082-25-SYS Guía de instalación Pagina 41