Enterasys 2S4082-25-SYS Guía de instalación descargar pdf (Pagina 55)

Connecting to COM Port for Local Management

Enterasys NAC Controller Hardware Installation Guide 4-15

5. Whentheseparametersareset,theLocalManagementpasswordscreenwilldisplay.Referto

theappropriateEnterasysMatrixDFE‐Diamond/PlatinumSeriesConfigurationGuideforfurther

information.

Figure 4-12 Connecting an IBM PC or Compatible

Connecting to a VT Series Terminal

ToconnectaVTSeriesterminaltoanEnterasys NetworkschassisCOMport(Figure 4‐13),usea

UTPstraight‐through cablewithRJ45connectorsandanRJ45‐to‐DB25femaleadapter,and

proceedasfollows:

1. ConnecttheRJ45connectoratoneendoftheUTPstraight‐throughcabletotheCOM

porton

theEnterasys Networksmodule.

2. PlugtheRJ45connectorattheotherendoftheUTPstraight‐throughcableintothe

RJ45‐to‐DB25femaleadapter.

3. ConnecttheRJ45‐to‐DB25adaptertotheportlabeledCOMMontheVTterminal.

4. TurnontheterminaltoaccesstheSetupDirectoryandset

thefollowingparameters:

Whentheseparametersareset,theLocalManagementpasswordscreenwilldisplay.Refertothe

EnterasysMatrixDFE‐Diamond/PlatinumSeriesConfigurationGuideforfurtherinformation.

1 UTP straight-through cablewith RJ45 connectors 3 RJ45-to-DB9 PC adapter

2 RJ45 COM port 4 IBM PC or compatible device

Parameter Setting

Mode 7 Bit Control

Transmit Transmit=9600

Bits Parity 8 Bits, No Parity

Stop Bit 1 Stop Bit

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 107 108

Sin comentarios

Enterasys 2S4082-25-SYS Guía de instalación Pagina 55