Enterasys 2S4082-25-SYS Guía de instalación descargar pdf (Pagina 43)

Installing Optional Mini-GBICs

Enterasys NAC Controller Hardware Installation Guide 4-3

3. Ifthereisaprotectivedustcover(seeinFigure 4‐1orFigure 4‐2)onthe Mini‐GBICport,do

notremoveitatthistime.

Installation

ToinstallaMini‐GBICwithanMT‐RJconnection,refertoFigure 4‐1,foranLCconnection,referto

Figure 4‐2,orforanRJ45connection,refertoFigure 4‐3,andproceedasfollows:

1. HoldtheMini‐GBICwithitstopsidefacingupandits7‐pinedge

connectorfacingtheport

slot.

2. CarefullyaligntheMini‐GBICwiththeportslot.

3. PushtheMini‐GBICintotheportslotuntiltheMini‐GBIC“clicks”andlocksintoplace.

Figure 4-1 Mini-GBIC with MT-RJ Connector

1 Mini-GBIC (MGBIC-MT01) 4 Port slot

2 Mini-GBIC

, top side 5 Mini-GBIC, protective dust cover

3 7-Pin edge connector (insertion side) 6 Release tab

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 107 108

Sin comentarios

Enterasys 2S4082-25-SYS Guía de instalación Pagina 43