Enterasys DFE-Platinum Series Guía de instalación descargar pdf (Pagina 100)

Memory Locations and Replacement Procedures

B-8 Mode Switch Bank Settings and Optional Installations

Figure B-8 Removing the Existing DRAM SIMM from 7H4382-49 or 7H4383-49

Installing the DRAM SIMM on 7H4382-49 or 7H4383-49

To install the memory module, refer to Figure B-9 and proceed as follows:

1. With the connector arms set in the open position, insert the memory module between the

connector fingers and push the memory module into the connector until the tabs on the two

connector arms pull in towards the DRAM SIMM alignment notches.

2. Push the DRAM SIMM further into the connector until the two DRAM SIMM alignment

notches and the tabs on the two connector arms lock the DRAM SIMM into place.

Connector arms

Memory module

Connector

Caution: Observe all antistatic precautions when handling sensitive electronic

equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las

precauciones de seguridad para evitar descargas de electricidad estática.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 109 110

Sin comentarios

Enterasys DFE-Platinum Series Guía de instalación Pagina 100