Enterasys DFE-Platinum Series Guía de instalación descargar pdf (Pagina 21)

About This Guide xix

About This Guide

This guide provides an overview, installation and troubleshooting instructions, and specifications

for the Enterasys Matrix

DFE-Platinum 7H4382-49, 7H4383-49, 7G4270-12, 7G4202-30,

7G4203-72 modules, and the Mini-GBIC modules.

For information about the CLI (Command Line Interface) set of commands used to configure and

manage the DFE modules, refer to the Enterasys Matrix DFE-Platinum Series Configuration

Guide.

WHO SHOULD USE THIS GUIDE

This guide is intended for a network administrator responsible for installing and setting up the

DFE modules.

Note: In this guide, the following terms are used:

• DFE refers to Distributed Forwarding Engine series of modules.

• DFE module or module refers to the 7H4382-49, 7H4383-49, 7G4270-12,

7G4202-30, or 7G4203-72. If the information applies only to one of the modules, the

module is referred to by its model number (such as 7H4382-49).

• Network Expansion Module or NEM refers to an optional uplink card installed on the

main logic board and accessible through the option slot of the 7H4382-49 or

7H4383-49.

• Mini-GBIC (Mini-Gigabit Interface Card) refers to a smaller optional interface card that

plugs into a NEM (network expansion module) or the 7G4270-12 port slots.

Electrical Hazard: Only qualified personnel should perform installation procedures.

Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de

instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und

qualifiziertes Personal vorgenommen werden.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 109 110

Sin comentarios

Enterasys DFE-Platinum Series Guía de instalación Pagina 21