Enterasys DFE-Platinum Series Guía de instalación descargar pdf (Pagina 65)

Connecting to COM Port for Local Management

Installation 3-29

3.8.2 Connecting to an IBM PC or Compatible Device

To connect an IBM PC or compatible device, running the VT terminal emulation, to an

Enterasys Networks module COM port (Figure 3-17), proceed as follows:

1. Connect the RJ45 connector at one end of the cable

➀ to the communications COM port ➁ on

the Enterasys Networks module. (The COM port is also known as a Console port.)

2. Plug the RJ45 connector at the other end of the cable

➀ into an optional RJ45-to-DB9

adapter

➂.

3. Connect the RJ45-to-DB9 adapter

➂ to the communications port on the IBM PC ➃.

4. Turn on the PC and configure your VT emulation package with the following parameters:

5. When these parameters are set, the Local Management password screen will display. Refer to

the appropriate Enterasys Matrix DFE-Platinum Series Configuration Guide for further

information.

Parameter Setting

Mode 7 Bit Control

Transmit Transmit=9600

Bits Parity 8 Bits, No Parity

Stop Bit 1 Stop Bit

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 109 110

Sin comentarios

Enterasys DFE-Platinum Series Guía de instalación Pagina 65