Enterasys Enterasys SecureStack B2 B2G124-24 Especificaciones descargar pdf (Pagina 36)

Using the Command Line Interface

1-6 Introduction

RefertotheinstructionsincludedwiththeTelnetapplicationfor informationaboutestablishinga

Telnetsession.

Logging In

Bydefault,theSecureStackB2sw itchisconfiguredwiththreeuserloginaccounts—rofor

Read‐Onlyaccess,rwforRead‐Writeaccess,andadminforsuper‐useraccesstoallmodifiable

parameters.Thedefaultpasswordissettoablankstring.Forinformationonchangingthese

defaultsettings,referto

“SettingUserAccountsandPasswords”onpage 3‐2.

Using a Default User Account

IfthisisthefirsttimeyouareloggingintotheSecureStackB2switch,orifthedefaultuser

accountshavenotbeenadministrativelychanged,proceedasfollows:

1. Attheloginprompt,enteroneofthefollowingdefault usernames:

– roforRead‐Onlyaccess.

– rwforRead‐Writeaccess.

– adminforSuperUseraccess.

2. PressENTER.ThePasswordpromptdisplays.

3. LeavethisstringblankandpressENTER.Theswitchinformationandpromptdisplaysas

showninFigure 1‐1.

Using an Administratively Configured User Account

Iftheswitch’sdefaultuseraccountsettingshavebeenchanged,proceedasfollows:

1. Attheloginprompt,enteryouradministratively‐assignedusernameandpressENTE R.

2. AtthePasswordprompt,enteryourpasswordandpressENTER.

ThenoticeofauthorizationandthepromptdisplaysasshowninFigure 1‐1.

Navigating the Command Line Interface

Getting Help with CLI Syntax

TheSecureStackB2switchallowsyoutodisplayusageandsyntaxinformationforindividual

commandsbytypinghelpor?afterthecommand.

CLI Command Defaults Descriptions

Eachcommanddescriptioninthisguideincludesasectionentitled“Defaults”whichcontains

differentinformationfromthefactorydefaultsettingsontheswitchdescribedinTable 1‐1.The

sectiondefinesCLIbehavioriftheuserentersacommandwithouttypingoptionalparameters

(indicatedby squarebrackets[]).Forcommands

withoutoptionalparameters,thedefaults

sectionlists“None”. Forcommandswithoptionalparameters,thissectiondescribeshowtheCLI

respondsiftheuseroptstoenteronlythekeywordsofthecommandsyntax.Figure 1‐2prov ides

anexample.

Note: Users with Read-Write (rw) and Read-Only access can use the set password command

(page 3-5) to change their own passwords. Administrators with Super User (su) access can use

the set system login command (page 3-4) to create and change user accounts, and the set

password command to change any local account password.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 599 600

Sin comentarios

Enterasys Enterasys SecureStack B2 B2G124-24 Especificaciones Pagina 36